P5/8/08
Page 9 of 26
10.
Attach the top bumper piece (length of PVC pipe) to the Swim Unit Housing through
the unused screw holes (top holes from Step 9) in the acrylic hanging bracket using
two (2) of the eight (8) stainless steel screws provided in Step 9.
NOTE: Do not
over-tighten.
11.
Attach the lower extension bumper (length of PVC pipe) to the rear of the Swim Unit
Base using the two (2) of the eight (8) stainless steel screws remaining from Step 9.
NOTE: Do not over-tighten.
12.
Attach the wheels to the Swim Unit base. Slide the axle through the two holes that
are marked in yellow on the intake grill in the Swim Unit base. These holes have
been widened to allow the axle to pass through freely. There is a total of four (4)
large and two (2) small washers used in the wheel assembly. Be sure that two large
washers are located between each wheel and the intake grill on the back bottom of
the Swim Unit base. Secure the wheels to the axle with one smaller washer between
the screw and the wheel on each side.
13.
Re-install the throat that was removed previously in Step 4.
14.
Place the Swim Unit on the ground and roll it close to the Fastlane Pool location for
installation. Be careful not to tip over the Swim Unit, as it is front-heavy.
15.
Once the pool is nearly full and the pool liner is taught and wrinkle-free, carefully lift
the assembled Fastlane Swim Unit into the pool at the skimmer end. Lower and
position the Swim Unit so that the acrylic hanger is resting on the wider top 130 cm
straight tube (B) as shown in the photo on the following page. It should be centered
between the two end struts (G).