P5/8/08
Page 21 of 26
USING YOUR FASTLANE SWIM UNIT
You are now ready to start up your Fastlane. Remove the remote from the Controller Box
on the hydraulic Power Unit and unwrap it. Press and hold the
ON/OFF
button to turn on
the Fastlane and produce a current.
The Fastlane features 52 incremental steps in speed. Press and release the
FASTER
button to increase the speed of the current one step at a time. Alternatively, press and
continue to hold the
FASTER
button to ramp up the speed until the button is released or
the maximum speed is achieved. Reduce the speed in the same manner using the
SLOWER
button.
Turn off the Fastlane by again pressing the
ON/OFF
button. Because the Fastlane
“remembers” the speed at which it was turned off, it will return to the same speed when it
is turned back on. NOTE: The circuit card on the hydraulic Power Unit is programmed to
ramp the speed of the current down before completely shutting off and ramp the speed
back up when turning the current it back on.
The hydraulic Power Unit controller is equipped with an automatic timer shutting off the
system thirty (30) minutes after receiving its last command.
INSTALLING AN ANTENNA EXTENSION
Your Fastlane remote control operates by radio waves. Should the hydraulic Power Unit be
placed too far away from the Fastlane Pool, your remote control may not operate
efficiently. To operate your Fastlane more effectively, please install the antenna remotely
with the enclosed kit. A longer length of coaxial cable can be used if you move the antenna
closer to your pool.
Parts List
"
10’ length of coaxial antenna cable
"
Coaxial grounding block (antenna mount)
Instructions
"
If the antenna is already installed, detach it from the upper left hand side of the
Controller Box mounted on the foot of the motor.
"
Attach and finger-tighten the antenna cable.
"
Attach the coaxial grounding block (antenna mount) to the surface where the
electrical disconnect box is mounted.
"
The antenna should be just above the height of the box so that the metal box does
not block the radio waves for your remote control.
NOTE: The antenna can be
placed even closer to the pool by purchasing antenna cable from a local
supplier.
"
Attach and finger-tighten the antenna to the upper end of the coaxial grounding
block (antenna mount).
