P5/8/08
Page 6 of 26
6.
Insert and connect the top corner tubes (D). It may be helpful to insert both ends of
corner tube (D) into the corresponding liner sleeves, followed by pulling back and
connecting one side at a time to top rail.
7.
Ensure all tubes completely nested in one another, connected correctly and that the
struts are perfectly aligned.
8.
Slowly begin to fill the pool with water until the bottom of the liner is taught.
Remove any wrinkles in the pool liner as this time as it will be difficult to do once the
pool is full.
9.
To prevent leaking issues, it is very important to plumb and plug both through walls
before the water level reaches the two pre-cut holes in the liner. For more
information, refer to the section in this Owners’ Manual titled, WATER QUALITY
SYSTEM, SKIMMER & THRU-WALL FITTINGS (starting on Page11).
10.
Once these holes have been plugged, assemble the Fastlane Swim Unit.
