2)
The battery will charge to at least 25% if it was discharged when last powered
down. This will be indicated with a warning triangle and the message “HVBMS SOC”.
(this could take up to 10 minutes to reach 25% charge)
3)
The AC6000 internal capacitor bank will charge to a working voltage. This will be
indicated by the message “BMS Precharge” (This should take less than 3 minutes)
4)
Power will be applied to the output
Firmware Versions prior to 1.7.5: The AC6000 will start in “Standby”. It will stay in this
state until it is powered on. Press and hold the power button on front of unit for three
seconds. As the AC6000 begins initialization, the power symbol will begin blinking. Note:
if the power symbol does not begin blinking, the power button may not have been held
down for a sufficient amount of time.
Figure 5.2-2: AC6000 Power Button Location
To shut-down the AC6000, simply hold the power button for 3 seconds. Countdown will
be initiated. Power icon will disappear when the shutdown is complete and it is safe to
disconnect.
5.3
Visual Verification
Check for display illumination and fan activity with no abnormal sounds.
Upon successful power-up, the display will indicate no faults or alerts. The default display
icons and their meanings are listed below. See alerts for more information.
NOTE: The unit will be in Standby Mode. The output connector will have no voltage
present unless auto-power on is configured for the unit and the unit is recovering for a
power failure.
Icon
Indicator
Description
Enconnex
Logo
Appears once the MCB is turned to the
ON position.
