Users’ Manual
EAN-26MH Horizontal inclinometer system
Page
|
20
Figure 18 shows the inclinometer probe being readied for calibration check. The protective end cap (B) of
the inclinometer probe has been removed. A special screw-on retainer cap (A) is used for anchoring the
inclinometer probe inside the guide during calibration check. This retainer cap is fixed to the calibration
jig when not in use.
The retainer cap is fixed to the inclinometer probe at one end. The anchoring screw (S), shown alongside
is screwed to the retainer cap from outside the inclinometer guide to anchor the inclinometer probe inside
the calibration check jig.
Figure 19 shows the inclinometer probe with cable connected being inserted inside the calibration jig
inclinometer guide casing. Note that the fixed set of wheels point downwards and the spring loaded
wheels point vertically upwards.
Figure 18 – Calibration jig & inclinometer probe with protective end cap, retainer cap and
anchoring screw
Figure 19 Calibration jig & inclinometer probe
Figure 20 – Calibration jig with anchoring screw (S) fixed
A
B
S
