Users’ Manual
EAN-26MH Horizontal inclinometer system
Page
|
7
2.7
Dummy probe model EAN-26MH/2.2
2.8
Calibration check jig model EAN-26MH/2.3
2.9
Operating cable and cable reel Model EAN-26MH/3.1
Two conductor stretch resistant polyurethane cable with Kevlar high tensile strength cable, graduated at
every 0.5 m. Length is as specified by the customer. A four pin connector is provided for connecting to
the probe. The cable reel comprises of a plastic winding reel to hold the specified length of cable.
2.10 Pulling cable with reel Model EAN-26MH/3.2
It is used to pull inclinometer probe from the other end. The pulling cable has one end with a threaded
connector, which is used to connect dummy or inclinometer probe or to an end cap (which is used as a
cover for ABS casing) when not in use. The other end is with an adjustable loop for anchoring hook in
reel while use or to protective cap when not in use. This cable is always left inside the casing, stretched
throughout the length, hooked to the end caps. For checking access tube and taking reading the
threaded end adaptor (figure 14) is fixed to the dummy or inclinometer probe and the pull cable loop is
fixed to the pull cable reel. The other end of the dummy/probe is fixed with operating cable.
Figure 5 – Calibration check jig
Figure 6 –Inclinometer Cable reel
Figure 4 Dummy Probe
