ENCAD 42e, Service Manual

Page: 64 / 162

Figure 3-18. Color Calibration.
The “Current Heads (Y, M, C)” view represents the alignment of the
heads as they are currently entered. This is just an overview of all
heads and how they are aligned. Do not attempt to align the heads
using this view.
The “Color Horizontal Head-to-Head Calibration” checks the align-
ment of the nozzles horizontally and allows corrections when re-
quired. Just enter the value below the set of lines that are correctly
aligned. Be careful that you are aligning the correct color by observ-
ing the C (cyan), M (magenta), and Y (yellow) on the right side of the
plot.
The “Color Vertical Head-to-Head Calibration” checks the alignment
of the nozzles vertically and allows corrections when required. Just
enter the value below the set of lines that are correctly aligned. Be
careful that you are aligning the correct color by observing the C
(cyan), M (magenta), and Y (yellow) on the right side of the plot.