ENCAD 42e, Service Manual

Page: 135 / 162

Assembly\Disassembly 135
ASSEMBL
Y/
DISASSEMBL
Y
Novajet PROe Series Service Manual
Install the Stabilizer Bracket and Encoder Strip
1. Install the Stabilizer Bracket Assembly (with Encoder Strip
and Trailing Cable) onto the Y-Arm Assembly using the four
alignment Allen screws and washers. Hand tighten only.
2. Install the Support Bracket onto the Stabilizer Bracket
Assembly by placing the Support Bracket onto the Stabilizer
Bracket with a slight forward tilt.
3. Perform the Install the Carrier Assembly, Carrier Belt, and
the Frame Tensioner Procedures to install the Carrier
Assembly, Carrier Belt, and the Frame Tensioner.
4. Perform steps 2 through 7 of the Install the Trailing Cable
Assembly procedures to finish installing the Trailing Cable
Assembly.
5. Perform the Install the Ink Delivery System procedures to
install the Ink Delivery System.
6. Perform the Install the Left, Top, and Right Covers
procedures to install the Left, Top and Right Covers.
7. Perform the Head Height Adjustment procedures found in
Chapter 3 of this service manual.
Remove the Y-Arm Assembly, Pinch Rollers, Slide
Shaft, and Auto-Load Sensor
1. Perform steps 1 through 13 of the Remove the Left, Top, and
Right Covers procedures to remove the Left, Top and Right
Covers.
2. Perform steps 2 through 6 of the Remove the Ink Delivery
System procedures to remove the Ink Delivery System.
3. Perform the Remove the Carrier Assembly, Carrier Belt, and
the Frame Tensioner procedures to remove the Carrier
Assembly from the Slide Shaft.