ENCAD 42e, Service Manual

Page: 97 / 162

Assembly\Disassembly 97
ASSEMBL
Y/
DISASSEMBL
Y
Novajet PROe Series Service Manual
3. Lift up on the left side of the Top Cover until it clears the Left
Cover while still depressing the retracting stop assembly, then
slide the cover to the left to disengage it from the Right Cover.
To remove the Right Cover Assembly:
Figure 5-1. Right Cover Assembly Removal/Installation.
4. With a #2 Phillips screwdriver, remove the three screws
securing the Right Cover Assembly to the Right Baseplate and
the two screws securing it to the Right Sideplate. See Figure
5-1.
5. Reach under the Support Bracket and depress and hold the
retracting stop assembly that secures the Right Cover
Assembly to the Support Bracket.
6. Carefully lift up on the Right Cover Assembly until it clears
the printer enough to gain access to the Keypad, Display, and
Backlight connections going to the Main Printed Circuit Board
(MPCB).
7. Disconnect the Keypad flex cable connection at the J13
location on the MPCB. See Figure 3-4 for jack locations on the
MPCB.
8. Disconnect the Display data ribbon cable connector at the J12
location on the MPCB.