ENCAD 42e, Service Manual

Page: 105 / 162

Assembly\Disassembly 105
ASSEMBL
Y/
DISASSEMBL
Y
Novajet PROe Series Service Manual
5. Disconnect the Stepper Motor connection at the J1 location
by grasping the Stepper Motor connector with thumb and
forefinger and pulling straight out.
6. Disconnect the Servo Motor connection (red and blue wires)
at the J2 location by grasping the Servo Motor connector with
thumb and forefinger and pulling straight out.
7. Disconnect the Leg Harness connection at the J3 location by
grasping the Leg Harness connector with thumb and
forefinger and pulling straight out.
8. Disconnect the Load Sensor connection at the J4 location by
grasping the Load Sensor connector with thumb and
forefinger and pulling straight out.
9. Disconnect the Vacuum Fan 1 connection at the J5 location by
grasping the Vacuum Fan 1 connector with thumb and
forefinger and pulling straight out.
10. Disconnect the Vacuum Fan 2 connection at the J6 location
(Pro 60e version only) by grasping the Vacuum Fan 2
connector with thumb and forefinger and pulling straight out.
11. Disconnect the Trailing cable connection at the J7 location.
Use the thumb and forefinger to pull up on the connector lock
and remove the Trailing Cable from the connector.
12. Disconnect the Power Supply Cooling Fan connection at the
J8 location by grasping the Power Supply Cooling Fan
connector with the thumb and forefinger and pulling straight
out.
13. With a #2 Phillips screwdriver, disconnect the ground straps
going to the side plate and baseplate by removing the screw
located near the parallel port on the MPCB.
14. Using care, remove the MPCB by unscrewing the remaining
screws securing the MPCB to the bracket using a #2 Phillips
screwdriver. See Figure 5-6.