MD21 Controller Setup
5.2 INSPECTION
Emulex products are shipped in special containers designed to
provide full protection under normal transit conditions.
Immediately upon receipt, please follow this procedure:
1.
Inspect the shipping container for evidence of possible
damage incurred in transit.
2.
Unpack the MD21 Controller and verify that all components
listed on the shipping invoice are present.
3. Verify that the model or part number (P/N) designation,
revision level, and serial numbers agree with those on the
shipping invoice.
These verifications are important to confirm warranty. If
evidence of physical damage or identity mismatch is found,
notify an Emulex representative immediately.
4.
Check the MD21 Controller after unpacking for bent or broken
connector pins, damaged components or any other evidence of
physical damage.
5.
Carefully examine all socketed components to ensure that
they are firmly and completely seated.
Report any obvious damage to the container, or indications of
actual or probable equipment damage, to the carrier company in
accordance with instructions on the form included in the container.
5.3 ND21 CONTROLLER SETUP
5.3.1 SWITCH SETTINGS
Some of the switches in DIP switch pack SWl on the MD21 Controller
allow configuration of various options available with the MD21.
All switches on the MD21 Controller are set to a standard
configuration before the MD21 Controller is shipped from the
factory.
Table 5-1 lists the function and factory settings of all
switches on the MD21 Controller. This subsection provides a
detailed description of the function of each switch.
NOTE
If the position of a switch on the MD21 is
changed, the host must issue a reset before that
switch change becomes permanent.
Installation 5-3
Summary of Contents for MD21/S2
