![background image](http://html.mh-extra.com/html/empire-comfort-systems/dvc26in71/dvc26in71_installation-instructions-and-owners-manual_2404055054.webp)
41380-0-0120
Page 54
Glass Door Removal
1. Remove the barrier screen. Press in and up at the top
of the barrier frame. Lift the barrier screen assembly up
approximately 3/8 inch until the bottom bracket is free from
the bottom of the glass door frame. Swing the bottom of the
barrier toward you until the barrier can be removed from the
top opening, which is the space between the surround and
insert top.
2. Locate the bottom two glass frame spring clamps. Pull
forward and down to release them from the Glass Door
frame.
3. Remove the Glass Door by pulling the bottom of the door
outward several inches, then lift upwards to disengage it
from the firebox upper flange.
5. Do not abuse the glass by striking or hitting the glass.
Glass Door Installation
1. When installing the Glass Door assembly, make sure that
the door top flange is hooked over the firebox top flange as
illustrated in the
“
Correct
”
view in Figure D.
Important: Do not allow the gasket across the top of the
door to roll up on top of the firebox flange as shown in
“Incorrect” view in Figure D.
2. To install correctly, the door should be held at an angle
outward from the firebox as shown in the illustration, then
carefully engage the upper flange of the door frame with the
top flange of the firebox. Center the door left to right, then
allow the bottom of the door to swing inward to seal against
the firebox front.
3. Once the glass door is placed flat to the firebox front edges,
engage the two spring latches to the bottom flange on the
glass door frame to secure the door assembly.
4. Replace barrier screen.
IMPORTANT
: Turn off the gas before servicing the appliance.
FIREBOX
TOP
CORRECT
FIREBOX
TOP
GASKET
INCORRECT
Figure D
Installation, maintenance and repair should be done by a
qualified service person. The appliance should be inspected
before use and at least annually by a qualified service person.
More frequent cleaning may be required due to excessive lint
from carpeting, bedding material, etc. It is imperative that control
compartments, burners and circulating air passageways of the
appliance be kept clean.
Have a Qualified Service Person:
•
Make a periodic visual check of pilot and burners. Clean and
replace damaged parts.
•
Examine and clean the vent system of the solid-fuel burning
fireplace.
•
Examine the venting system periodically and replace any
damage parts
•
Clean burner and control compartment.
Clean Burner and Controls
Frequency:
Once annually.
By:
Qualified service technician.
Task:
Brush or vacuum the control compartment, fireplace logs
and burner areas surrounding the logs.
Check Flame Patterns, Flame Height
Frequency:
Periodically.
By:
Qualified service technician/Home owner.
Task:
Make a visual check of your fireplace insert’s flame
patterns.
Make sure the flames are steady - not lifting or floating. The
thermopile/thermocouple (standing pilot) tips should be covered
with flame.
See Figure F.
Check Vent System
Frequency:
Before initial use and at least annually thereafter,
more frequently if possible.
By:
Qualified service technician/Home owner.
Task:
Inspect the external vent cap on a regular basis to ensure
that no debris is interfering with the flow of air. Inspect entire vent
system for proper function.
Clean Logs
Frequency:
Periodically
By:
Qualified service technician
Task:
Use a soft brush attachment on a vacuum cleaner to gently
remove dust or soot deposits from logs and burner.
IMPORTANT INFORMATION