eMotions TM 2005 Blosil Enterprises, LLC. Produced under License by OESD, Inc. All manual contents (C) 2005 OESD, Inc.
39
Error Codes and Troubleshooting
Error Codes
E
rr
o
r
C
o
d
e
s
a
n
d
T
ro
u
b
le
sh
o
o
tin
g
Error
11
12
13
14
15
16
22 & 23
25
bob
Problem
Needle is in the fabric and
the hoop cannot move
Card was removed.
Upper Thread Broken
Presser foot needs to be
lowered
Presser foot needs to be up
Bobbin Winder is engaged.
Design is too large to sew.
-X limit reached
Bobbin winder engaged
Solution
Turn the Balance Wheel until
the needle is at its highest
point.
Do not remove the card
while the machine is on.
Re-thread the needle or
check to see if the thread is
not in all the tensioners. If
this happens at the begin-
ning of the design, hold the
thread taut when you press
the START/STOP button.
Lower the presser foot with
the presser foot lever
Raise the presser foot with
the presser foot lever.
Push the Bobbin winder to
the left to disengage it.
Choose another design or
make the design smaller us-
ing the software.
Start design in center of
hoop and trace to make sure
design will fit and restart
design.
Move bobbin winder to the
left to disengage it.
continued on next page
eMotions Manual 7x9.indd 39
7/22/2005 11:11:22 AM
