eMotions TM 2005 Blosil Enterprises, LLC. Produced under License by OESD, Inc. All manual contents (C) 2005 OESD, Inc.
33
If not enough bobbin thread is showing on the wrong side of the
embroidery, turn the screw ¼ turn to the left to loosen the tension.
Replace the bobbin case. The Hook Tab should be to the left of the
Hook with the fuzzy part under the bar. Replace the stitch plate.
Make sure the screws are in as far as they will go. Tighten hand
tight. Do not use any mechanical devices to screw in the screws.
Put the bobbin back in the bobbin case according to the image on the
bobbin case and replace the plastic cover onto the stitch plate.
Test the embroidery again to see if further adjustments are needed.
Never adjust more than ¼ turn at a time.
Changing a Needle
If you break a needle while sewing, stop the machine immediately.
Change the needle according to the instructions below.
Use embroidery needles with your eMotions embroidery machine.
Embroidery needles are made for the higher speeds of embroidery
machines. Regular sewing needles are not recommended, but
will not damage your machine. We recommend Organ Brand
embroidery needles, which are included with the machine.
Changing the needle should also be done at regular intervals to keep
your eMotions machine running well and your embroidery looking
good. A good time to change the needle is when you start a new
project. Needles should be changed at intervals no longer than
four to six hours of sewing time. (You can figure your sewing time
by dividing the number of stitches by 500. This will give you the
number of approximate minutes it will take the machine to sew out
the design, i.e. 5000 stitches divided by 500 is 10. The design will
take approximately 10 minutes to sew out.)
To change the needle in your eMotions machine, you will need the 3-
way screwdriver tool that came with your machine or a short flat
blade screwdriver.
O
p
e
ra
tio
n
eMotions Manual 7x9.indd 33
7/22/2005 11:11:20 AM
