2
3402105000_31-P5710TG 105 × 148 mm
ADDITIONAL PUSH BUTTON P5710TG
For doorbell types P5710G (P5710G) , P5710G-2T (P5711G), P5710G-2R (P5713G).
Technical specification
Transmission range:
up to 100m in open area
Waterproof pushbutton:
with IP44 coverage
Pairing method: self-learning function
Number of melodies:
3 – possibility to set different melody for more pushbuttons (max 3) used
Power of pushbutton:
1× 12V battery (type A23)
Packaging includes:
Double side sticker
Pairing of bell unit with pushbutton
1. Remove the back casing of the pushbutton through the hole in the side of the casing with a screwdriver. Insert 1pc of 12V
battery (type 23A) according to the polarity indicated.
2. Press the button “SW2” on the printed circuit board once – signaling LED of transmitter turns on for 5 seconds. Within these
5 seconds, press the button “SW2” once again - signaling LED blinks three times meaning, that new code was generated.
3. Reassemble the pushbutton casing.
4. If you need to pair more pushbuttons, repeat points 1. – 3. for each pushbutton.
5. Plug in the bell unit (RX), the learning mode is entered automatically for two minutes and signaling LED on bell unit blinks.
6. Within these two minutes press the desired pushbutton, if bell unit receives TX signal, it will play the melody corresponding
to which selected at pushbutton (TX).
7. If you need to pair more pushbuttons, repeat point 6. also for other pushbuttons.
SW2
choice of melody
Choice of melody
Melody can be changed anytime. It won’t affect communication between paired bell unit and pushbutton.
1. Remove the back casing of the pushbutton through the hole in the side of the casing with a screwdriver.
2. There are 3 pins with jumper on the printed circuit board. Choose one of three melodies with:
- connecting pins 1 and 2
-.connecting pins 2 and 3
-.removing the jumper (no pins are connected)
3. Reassemble the pushbutton casing.
Pushbutton installation
1. Firstly proceed the pairing of bell unit with pushbutton.
2. Before you start mounting, make sure that the chime works properly on the place you have chosen.
3. Remove the back casing of the pushbutton through the hole in the side of the casing with a screwdriver.
4. Place this back casing outside your home. Use double side sticker (included) or screws to fix it on the wall. Although the
pushbutton is waterproof, it is better to place it under the shelter.
5. Reassemble the pushbutton casing.
6. Press the button, signaling LED on the pushbutton indicates that radio signal was transmitted. Bell unit sounds chosen
melody.
7. If the signaling LED does not light, battery is flat, please replace it. Battery usually last for one year but it may differ according
to conditions.
Note: The pushbutton unit can be placed on wooden or brick walls, however, do not place it on metal surfaces or surfaces
containing metal. It might affect the correct function of the unit.
Maintenance
The wireless digital chime is a sensitive electronic device therefore it is necessary to follow these instructions:
• Check the bell and pushbutton frequently and change the battery in the pushbutton with a good quality alkaline battery
after a period of time.
• Keep the door button away from metal surfaces such as UPVC doorpost that has a steel center core.
• If the unit is left unused for a long period of time, remove the battery.
• Do not expose either the bell unit or the pushbutton to excessive shocks.
• Do not expose both the bell unit and the pushbutton to direct sunlight or moisture.
• Do not use any depurators to clean the doorbell.
• Do not intervene in the inside of the doorbell.
GB
