3
3a
1
2
2
3
4
5
1
6
7
10
11
11
8
8
9
5
4
Manual Twin Nitro v. 1.4
62
Assembly the pram
Assembly of the seat unit
WARNING
• Make sure that children are kept away from moving parts when
assembling the pram, otherwise they might be at risk of injury.
Unfolding the chassis (seat unit fabrics are not shown in order to
make the instructions clearer)
• Apply the brake on the pram. To unfold the chassis, pull the handle
upwards whilst you are holding down the side of the chassis. The
safety catch (1) is activated to prevent unintentional folding if the
chassis lock (2) is not locked into position.
WARNING
• The chassis locks need to click into the locked position.
• Always check before you use the pram that the chassis lock (2) is
in the locked position otherwise the pram will be dangerous to use.
Attaching the rear wheels
• Remove the plastic protection from the axles. Save them for future
use.
• Release the brake by pushing the brake pedal upwards using mini-
mum force with your foot.
• Press in the hub cap’s release button (3 or 3a), push the wheel
onto the axle as far as it can go. Release the button and pull the
wheel towards you until you hear a definite click. Repeat the same
procedure for both rear wheels. Always check that the wheels are
attached properly and cannot be pulled off the axle.
IMPORTANT
• The wheels are greased and can leave marks on textiles. Please
use wheel protection indoors to protect your floors.
• Risk of suffocation. Don’t allow your child/children to play with or
handle the plastic protectors.
Attaching the tray
• Attach the tray to the rings on the chassis (4)
• Fasten the tray around the brake axle (5)
• Place the shoulder straps (7) through the holes in the back of the
seat unit fabrics.
• Place the waist straps (8) through the holes in the seat fabrics.
• Place the crutch straps (9) through the holes in the base board and
the seat unit.
• Place the shoulder harness pads over the two shoulder straps (10).
Attach the shoulder straps to the waist harness with the lock (11).
• Attach both waist harnesses in the central lock.
• Release the shoulder and waist straps from the harness lock before
you assemble the seat unit. Place the seat unit fabric's back pocket
(6) over the seat unit's backrest.
• Make sure that the seat unit fabric’s back pocket is pulled as far as
it will go over the seat unit’s backrest.
WARNING!
• It is important that the seat unit fabric’s back pocket is pulled com-
pletely over the backrest as far as it will go.
• Make sure that the backrest is locked into a safe position before it
is used. This step is very IMPORTANT.