EMINENTCYCLES.COM
18
STEM
We have provided your bike with two 5mm headset
spacers above and below the stem. This allows the up
and down adjustment of the stem by a total of 10mm
from the center position. If you feel that the handlebars
are too low or high after adjusting your seat and bars
rotation, you will need to adjust your stem height.
Warning:
The front wheel must be on the ground before
loosing the stem cap preload bolt and binding bolts.
Step 1: Remove the top cap and loosen the two binding
bolts on the stem with the supplied Allen tool. If the
handlebars are too low, remove a spacer on top of the
stem and place it under the stem. If the handlebars are
too high, remove a spacer under the stem and place it on
the top of the stem.
&
IMAGE 8
Step 2: Reassemble the top cap and preload bolt and
hand-tighten. If the preload bolt is too tight it will add
resistance to the steering movement.
Step 3: Align the handlebars to the front tire and tighten
the two binder bolts to
5Nm
using the supplied Allen
torque tool. Repeat if needed to obtain the desired
position.
SET
UP
Summary of Contents for HASTE
