18
|
ENGLISH
8.0 Setting up an alarm notification
You can setup the surveillance recorder in such a way, an alarm notification will be
given at the same moment motion is detected. Also, you can setup the amount of time
this alarm notification will last. This alarm notification can be a buzzer (beeping
sound), e-mail, snapshot and an alarm output. Use the following steps to setup an
alarm notification.
8.1 Setting up an alarm notification during motion
detection
1. Make sure the surveillance recorder is completely started and you see the
surveillance recorder’s image on screen.
2. Click ‘Start’.
3. You need to login using an admin account. Fill out the password you have set
during the wizard and click ‘Login’ or do not fill out a password if you have not
used the wizard or if you do not have set a password and click ‘Login’.
4. Click ‘Advance’.
5. Click the ‘Settings’ field below ‘Trigger’.
6. Select the type of alarm notifications: You can choose between ‘Record’,
‘Snapshot’, ‘Send E-mail’ and ‘Alarm output’. You can also make an extra
selection at ‘Alarm output’. You can select a ‘Buzzer’ and the duration of this
‘Buzzer’ sound. For Example: Select ‘10s’ at ‘Buzzer’. This means a buzzing
sound will be heard during ten seconds if motion is detected. You can also set the
duration of the recording time if motion is detected at ‘Pre-record’ and ‘Post
record’ (‘Record’ needs to be enabled’.
7. Click ‘OK’.
8. Click ‘Apply’.
9. Click ‘OK’ at the ‘Successfully saved’ screen.
10. Click ‘Exit’ until you are at the main menu’.
8.2 Sending an email during alarm notification
Hint: It is also possible to setup the e-mail option using the web interface of the
recorder. Setting up the e-mail option using the web interface is usually faster and
easier. Once the settings have been saved using the web interface, the settings will be
saved to the surveillance recorder itself.
1. Make sure the surveillance recorder is completely started and you see the
surveillance recorder’s image on screen.
2. Click ‘Start’.
3. You need to login using an admin account. Fill out the password you have set
during the wizard and click ‘Login’ or do not fill out a password if you have not
used the wizard or if you do not have set a password and click ‘Login’.
4. Click ‘Advance’.
5. Click ‘Comm’.
