17
|
ENGLISH
mouse button and keeping it pressed while simultaneously moving the mouse, you
can select a specific area on screen. The selected area will be given a grey
colour. It means the grey coloured area is excluded from motion detection. If
movement is detected in a motion detected area (green colour), the grid will revert
to a red colour.
10. Click the right mouse button once.
11. Click ‘Apply’.
12. Click ‘OK’ at the ‘Successfully saved’ screen.
13. Click ‘Exit’ until you are at the main menu.
7.5 Time based recording with motion detection
Making recordings using motion detection on specific times, saves hard disk space
compared to other methods of recording. Therefore, older recordings will be stored
longer. ‘Time based recordings with motion detection’ is recommended to use.
1. Make sure the surveillance recorder is completely started and you see the
surveillance recorder’s image on screen.
2. Click ‘Start’.
3. You need to login using an admin account. Fill out the password you have set
during the wizard and click ‘Login’ or do not fill out a password if you have not
used the wizard or if you do not have set a password and click ‘Login’.
4. Click ‘Advance’.
5. Click the ‘Settings’ field below ‘Schedule’.
6. In the following screen you will see the days of the week (Sun. till Sat.).
7. If you want the surveillance recorder to start recording in case an event occurs
during a selected time frame, you need to make sure ‘Alarm’ is selected. Also
refer to chapter 8.
8. Select a red coloured square next to a day and double-click this square.
9. You can now select a ‘Start time’ and an ‘End time’. This means, if you have set
the ‘Start time’ to ’22:00:00’ and the ‘End time’ to 23:59:00’, the alarm
notification(s) will become active between ’22:00 and 23:59’. If motion is detected
during this time frame, an alarm notification will become active and this ‘event’ or
motion detection will be recorded.
10. Click ‘OK’.
11. Click ‘Apply’.
12. Click ‘OK’ at the ‘Successfully saved’ screen.
13. Click ‘Exit’ until you are at the main menu’.
If you want to use the ‘standard’ recording during a specified time, instead of recording
during an event, then select ‘None’ instead of ‘Alarm’. Only a recording will take place
the moment motion is detected.
