Page: 22
Emerson.com/SolaHD
User Guide
A272-365
3. MONITORING
6/2022
3. MONITORING
3.1 WEBSERVER MONITORING
3.1.1 PROCEDURE
The SCM-E-EIP Communication Module comes with a webserver Graphical User Interface (GUI) that
allows the user to monitor the different parameters and alarms from the device connected to it. It also
allows the user to configure SCM-E-EIP network settings such as IP address and net mask.
This webserver can be opened by most browsers such as Google Chrome, Microsoft Edge, Mozilla
Firefox, Safari, etc.
To open the SCM webserver, follow the instructions below:
1.
Set-up the wiring of the SCM-E-EIP and the SOLAHD Power Supply. For information on the wiring
setup of SOLAHD Power Supplies to the SCM-E-EIP, refer to
Section 1.5.1
.
2.
Once the setup is finished, turn the devices on and configure the network. For instructions on how
to configure the network, refer to
Section 2.1
. If the network is already configured, this step can
be skipped.
3.
To make sure that the SCM is really connected to the network, the user can ping the device by
typing ping 192.168.1.5 on the command prompt. Command Prompt can be opened by typing
cmd to the Windows search bar and pressing Enter. (This step can be skipped.)
4.
Once the connection is established, open the desired browser and type the IP address (192.168.1.5)
on the address bar.
5.
The webserver should be loaded with the default tab opened (Overview tab).
