28
SI-DeviceNet User Guide
Issue Number: 2
6.3
Module menu 1 - DeviceNet Setup
Menu 1 contains all the parameters relating to the setup of the DeviceNet interface on
the SI-DeviceNet module.
This parameter displays a value of On (1) to indicate that the DeviceNet Interface has
been enabled.
Changes to the SI-DeviceNet configuration will not take effect until the SI-DeviceNet
has been reset.
To reset the SI-DeviceNet:
•
Set Pr
S.01.002
to On (1).
•
When the sequence has been completed, Pr
S.01.002
will be reset to Off (0).
•
The SI-DeviceNet will reset using the updated configuration.
If the host drive is defaulted (see the drive user guide for details), it will also clear the
current configuration for the slot SI-DeviceNet is installed to.
This can be performed as follows:
•
Set Pr
S.01.003
to On (1).
•
Reset the DeviceNet interface by setting Pr
S.01.002
to On (1).
•
SI-DeviceNet communications will be stopped.
•
Default parameter values for the DeviceNet interface will be loaded.
•
The SI-DeviceNet will reset using the default values.
Every node on a DeviceNet network must be given a unique network node address. To
activate a change in the node address value, the SI-DeviceNet must be reset
(Pr
S.01.002
or
MM.007
= On (1). Address number 63 is reserved for system use.
Enable DeviceNet Interface
S.01.001
Default
On (1)
Range
Off (0) or On (1)
Access
RO
Reset DeviceNet Interface
S.01.002
Default
Off (0)
Range
Off (0) or On (1)
Access
RW
This sequence does NOT store the SI-DeviceNet configuration parameters in the drive
or the SI-DeviceNet flash memory. This parameter will change back to Off immediately,
and as such the change may not be visible in the display.
NOTE
Default DeviceNet Interface
S.01.003
Default
Off (0)
Range
Off (0) or On (1)
Access
RW
DeviceNet node address
S.01.004
Default
63
Range
0 to 63
Access
RW
