Emerson Rosemount FCL, Reference Manual

Page: 33 / 108

2. To assign values to the analog outputs, you must open the
Program
sub-menu. Use
Down to move the cursor to Program. Press ENTER .
The Program menu appears. There are between five and seven items in the
Program
menu. Diagnostic Setup appears only if you have the Rosemount
™
FCL-02
with pH sensor. The screen displays four items at a time. The downward pointing
arrow on the right of the screen shows there are more items available in the menu.
3. To view the other items, use Down to scroll to the last item shown and continue
scrolling down. When you have reached the bottom, the arrow will point up. Move
the cursor back to Outputs and press
ENTER .
The
Outputs
screen appears. The cursor is on Range. Output range is used to assign
values to the low and high current outputs.
4. Press
ENTER
.
The Output Range screen appears. The screen shows the present values assigned
to output 1 (O1) and output 2 (O2). The screen also shows which sensors the
outputs are assigned to. S1 is sensor 1.. The assignments shown are the defaults for
the Rosemount FCL-01. Outputs are freely assignable under the
Configure menu.
5. For practice, change the 20 mA settings for output 1 to
8.5 ppm
.
a) Move the cursor to the O1 S1 20 mA: 10.00 line and press
ENTER
.
The screen below appears.
Reference Manual Display and operation
00809-0100-3412 May 2019
Rosemount FCL 1056 33