Reference Manual
00809-0100-4856 Rev AE
February 2020
Rosemount 356
A-3
REQUIRED TOOLS FOR
ASSEMBLY
Tools required for assembly of the 356 Field Side connector are listed
in Table A-2. If a Rosemount part number is not specified, any
general brand tool that meets the specifications can be used. Please
contact Rosemount Nuclear with any questions regarding the
required tools.
Table A-2 – Tools Required for
Assembly of the Field Side
ASSEMBLY
PROCEDURES
The following procedures describe the proper steps to follow to
assemble the field side connector in the qualified configuration.
NOTES
•
Some instructions may require modification depending on
instrumentation cable and number of wires. Please contact
Rosemount Nuclear for technical assistance.
•
The following procedures and photos demonstrate the assembly
process using the Side Entry Hood (see Figures 3-3 and 3-5). The
Top Entry Hood (see Figures 3-2 and 3-4) is assembled in an
identical manner.
•
Each step in the following procedures is accompanied by a photo
directly below the instructions demonstrating the associated
activity.
•
Use crimp tool as specified to ensure strength of crimped
connection meets requirements specified by IEC 60352-2 Table 1.
Description
Rosemount
Part Number
Photo
Crimping tool with
locator
00356-0504-
0001
Wire Stripper
Customer
Supplied
Small Flat-head
Screwdriver
(3.5mm-5mm)
Customer
Supplied
22mm Open-end
Wrench
(Quantity of 2 required)
Customer
Supplied
25mm Open-end
Wrench
Customer
Supplied
22mm Open-end Torque
Wrench (30 N-m /
22 ft-lb)
Customer
Supplied
Crimp contact removal
tool (recommended)
00356-0505-
0001
