b) Select
ADVANCED
.
c) Select
Proceed to 192.168.192.168
.
d) At the login screen, enter:
Default username:
epson
Default password:
epson
The EpsonNet Config utility screen displays.
e) Select
TCP/IP
under the configuration settings (not the basic settings), listed
on the left side of the screen.
f) Change the
IP Address
(i.e., 192.168.1.55),
Subnet Mask
, and
Default
Gateway
based on your network. Select an IP address that is unique to the
local network.
The printer must be on the same subnet as the 1600.
g) Required: Set
Acquiring the IP Address
to Manual.
h) Select
Send
to save your settings.
i) Select
Reset
, or power cycle the printer when prompted to apply the
changes.
6. Change the PC network settings back to the original settings.
Use the windows you used in
.
7. Configure the 1600 Ethernet transmitter for the printer.
a) Remove the Ethernet cable from the PC and connect it to the 1600 Ethernet
transmitter.
b) If you have not already done so, configure the transmitter IP address, subnet
mask, and default gateway.
Display
Menu
→
Configuration
→
Ethernet Settings
→
Network Settings
ProLink III
Device Tools
→
Configuration
→
Network Settings
For instructions on how to configure the transmitter and PC Ethernet
settings, see the
Micro Motion 1600 with Ethernet Transmitters: Configuration
and Use Manual
.
c) Enter the printer IP address you configured in the previous step into the 1600
Ethernet transmitter.
Display
Menu
→
Configuration
→
Printer
→
Printer IP
address
ProLink III
Device Tools
→
Configuration
→
Printer and Tickets
Web browser
Configuration
→
Printer and Tickets
Set up the printer
Installation Manual
March 2022
00825-0100-1600
30
Micro Motion 1600 Ethernet Transmitters
