Emerson Location Awareness, Quick Start Manual

Page: 2 / 36

Emerson Location Awareness safety messages
Read this Quick Start Guide before working with the product. For personal and system safety and for
optimal product performance, understand the contents completely before installing, using, or
maintaining this product.
Emerson has two toll-free assistance numbers and one international number.
NOTICE
Customer Central
1 800 999 9307 (7:00 a.m. to 7:00 p.m. CST)
National Response Center (equipment service needs)
1 800 654 7768 (24 hours a day)
International
1 952 906 8888
Nuclear qualification
The products described in this document are NOT designed for nuclear-qualified applications. Using
non-nuclear qualified products in applications that require nuclear-qualified hardware or products may
cause inaccurate readings. For information on Rosemount
™ nuclear-qualified products, contact an
Emerson Sales Representative.
Wireless Gateway
The Location Anchor and all other wireless devices should be installed only after the Wireless Gateway
has been installed and is functioning properly. Wireless devices should also be powered up in order of
proximity from the Wireless Gateway, beginning with the closest. This will result in a simpler and faster
network configuration. Use caution when making changes to the TCP/IP network settings. If they are
lost or entered incorrectly, the Gateway will require a factory reset. Contact your network
administrator for information on the proper TCP/IP network settings.
Hazardous substance
Individuals handling products exposed to hazardous substances can avoid injury if they are informed of
and understand the hazard. If the returned product was exposed to a hazardous substance as defined
by OSHA, a copy of the Material Safety Data Sheet (MSDS) for each hazardous substance identified
must accompany the returned goods.
Shipping considerations
The Location Anchor unit was shipped with the battery installed. Each Location Anchor contains one
“D” size primary lithium battery. Primary lithium batteries are regulated in transportation by the U. S.
Department of Transportation and are also covered by the International Air Transport Association
(IATA), International Civil Aviation Organization (CAO), and European Ground Transportation of
Dangerous Goods (ARD). It is the shipper’s responsibility to ensure compliance with these or any other
local requirements. Consult current regulations and requirements before shipping. The polymer
enclosure has surface resistivity greater than one giga-ohm. Take care during transportation to and
from the configuration point to prevent a potential electrostatic charging hazard.
Battery considerations
Battery hazards remain when cells are discharged. Electrostatic discharge can damage electronics.
Batteries should be stored in a clean dry area. For maximum battery life, storage temperature should
not exceed 30 °C (86 °F). The Location Anchor battery shall only be replaced in a non-hazardous area.
The Personnel Tag battery is rechargeable and shall only be charged in a non-hazardous area using a Qi
certified charger.
Quick Start Guide February 2020
2 Emerson.com