29
;
; slave-specification:
;
DPV1_slave=1
;
c1_read_Write_supp=0
c2_read_Write_supp=1
c2_Max_Data_Len=240
c2_response_timeout=100
c2_read_Write_required=0
c2_Max_count_channels=3
Max_Initiate_PDu_Length=72
Diagnostic_alarm_supp=0
Process_alarm_supp=0
Pull_Plug_alarm_supp=0
status_alarm_supp=0
update_alarm_supp=0
Manufacturer_specific_alarm_supp=0
Extra_alarm_saP_supp=0
alarm_sequence_Mode_count=0
alarm_type_Mode_supp=0
Diagnostic_alarm_required=0
Process_alarm_required=0
Pull_Plug_alarm_required=0
status_alarm_required=0
update_alarm_required=0
Manufacturer_specific_alarm_required=0
DPV1_Data_types=0
WD_base_1ms_supp=1
check_cfg_Mode=0
;
;Device related Diagnosis
;
unit_Diag_bit(24)=’not Operative Open’
unit_Diag_bit(25)=’not Operative close’
unit_Diag_bit(26)=’Power fail alarm’
unit_Diag_bit(27)=’HI-HI torque in Opening’
unit_Diag_bit(28)=’HI-HI torque in closing’
unit_Diag_bit(29)=’stroke Limit alarm’
unit_Diag_bit(30)=’Local control alarm’
unit_Diag_bit(31)=’Motor Direction alarm’
Unit_Diag_Bit(32)=’Jammed Valve’
unit_Diag_bit(33)=’Hardware Error’
unit_Diag_bit(34)=’Postition sensor failure’
unit_Diag_bit(35)=’HI-HI temperature’
unit_Diag_bit(36)=’Local configuration in progress’
;
; Module Definition List
;
Module=’Mod.1: 2 b.In, 1 b.Out’ 0x11,0x20 1
EndModule
Module=’Mod.2: 6 b.In, 4 b.Out’ 0x15,0x23 2
EndModule
Module=’Mod.3: 2 b.In, 1 b.Out - cons.’ 0x91,0x20 3
EndModule
Module=’Mod.4: 6 b.In, 4 b.Out - cons.’ 0x95,0xa3 4
EndModule
Keystone
OM9 - EPI2 PrOfIbus DPV1 IntErfacE
InstallatIon & MaIntenance InstructIons
