5
Standby/On Switch
Toggle switch for either STANDBY
mode or ON for normal operation mode.
Power Indicator Light
This light is on if the plug-in transformer
is plugged in and there is power to the
unit. It is not on if the unit is operating
on battery power only.
Alarm Indicator Light
This light will FLASH if the unit is in
the STANDBY mode. During normal
operation with no alarms present, this
light will not be on. This light will
remain ON and not flash if the unit is in
ALARM mode, meaning one of the
alarm conditions exists or the alarm call-
out has not been canceled.
Program Phone Jack
Plug in a phone here to either locally
program your FreezeAlarm or to locally
check status or cancel alarm call-outs.
For normal operation, you will not
leave a phone plugged into this jack.
Phone Jack
Plug in the supplied telephone cord here.
The other end plugs into your telephone
wall jack (or through a surge suppressor
that has the ability to protect the phone
line). See the “connections” section later
in the manual for more details.
Dip Switches
There are seven dip switches that are
used to select various features and
functions of your FreezeAlarm. Note
that the UP position of the switch is
towards the top of the FreezeAlarm’s
case and DOWN is towards the bottom.
Sensor Input Jack
Use this to plug in the temperature
sensor. This jack is a slightly smaller
than a normal phone jack. This is done
to prevent accidental input of the phone
line into this jack which could cause
harm to the FreezeAlarm.
9 Volt Battery Connection
This is where you will plug in your 9
volt lithium battery.
Plug In Transformer Connection
This is where you will plug in the
transformer that is included with your
FreezeAlarm.
