14
3.
Press 0 so you can change the Alarm or Greeting Message
4.
The FreezeAlarm will begin playing the menu prompt shown below.
While
this message is playing, press the # key.
The menu prompt will stop and the
FreezeAlarm will now play the factory default greeting or alarm message.
“
Begin Recording after the tone.
When you have finished recording, press the pound (#) key”
2.3 Programming Your FreezeAlarm Locally:
At the location where the FreezeAlarm is located
1.
Make sure the toggle switch on the front of the FreezeAlarm is on the STANDBY
position for programming. The ALARM light on the front of the FreezeAlarm will
begin flashing.
2.
Make sure you have a regular, single line telephone plugged into the front of the
FreezeAlarm where it says PROGRAM PHONE. This will be referred to as your
Programming Phone. NOTE: After programming is completed, unplug the
Programming Phone from the PROGRAM PHONE jack on the front of the
FreezeAlarm. A phone left plugged into the front of the FreezeAlarm cannot
operate as a regular telephone. If you want to share a phone with your
FreezeAlarm in the same wall jack, you will need a telephone jack line splitter.
See the
Connecting Cords, Sensor and Battery
section on page 8 for more
information.
3.
Pick up the handset on your Programming Phone. The FreezeAlarm will begin
talking to you with the Main Menu.
Main Menu:
You are now in the main menu.
For current status, press 1.
To enter the Program Menu, press 2.
Current Status:
Provides the current status of the various sensors.
The current temperature is XX degrees, the power is on (or off), and
the battery is at X.XX volts.
Program Menu:
The FreezeAlarm is programmed here. Earlier in the
manual, each menu option is explained in detail. In addition, Appendix A
has a full flow chart showing the entire menu layout. You may want to
listen to all the menu options before proceeding so you can hear all the
options. At the end of the menu, it will pause and then start playing from
the beginning again.
4.
IMPORTANT:
Flip the front ON/STANDBY switch to the ON position for
normal operation of your FreezeAlarm.
2.4 Programming Your FreezeAlarm Remotely:
By calling into your FreezeAlarm from a remote phone or cell phone