S600+ Instruction Manual
Revised July-2017
Startup
7-5
1. TCP/IP ADDRESS 1
2. GATEWAY ADDRESS 1
3. SUBNET MASK 1
4. TCP/IP MODE
5. GO BACK
Figure 7-4. Network Definition Menu
3.
Select
TCP/IP ADDRESS 1
. The system prompts you to enter a
valid TCP/IP address.
4.
Enter an address and press
Enter
.
Note
:
If the TCP/IP, gateway address, or subnet mask values are
correct, press
CLEAR
to accept the displayed value and
return to the Network Definition menu.
5.
Select
GATEWAY ADDRESS 1
. The system prompts you to
enter a valid gateway address.
6.
Enter an address and press
Enter
.
7.
Select
SUBNET MASK 1.
The system prompts you to enter a
valid subnet mask.
8.
Enter a valid subnet mask and press
Enter
.
9.
Press
4
, then
6
to return to the Startup menu.
Modbus Address
If you specify a zero address for a Modbus slave configuration, the
S600+ configures the Modbus port using the address you enter here.
This is helpful when you load the same configuration file into multiple
S600+s on the same Modbus address: each S600+ then has a unique
node address.
To define the Modbus network address:
1.
Select
NETWORK SETUP
from the Startup menu.
2.
Select
MODBUS ADDRESS
. The Modbus Address screen
displays:
Summary of Contents for FloBoss S600+
Page 66: ...S600 Instruction Manual 4 28 I O Revised July 2017 This page is intentionally left blank ...
Page 114: ...S600 Instruction Manual A 8 Glossary Revised July 2017 This page is intentionally left blank ...
Page 150: ...S600 Instruction Manual C 28 Chromatographs Revised July 2017 2350 USA 2551 USA ...
