6
100-412-183 REV. 13
1.2.1
Intended Use of the System
The DCX S Power Supply and components are designed to be used as part of an ultrasonic
welding system. These are designed for a wide variety of welding or processing
applications.
1.2.2
Emissions
When being processed, certain plastic materials can emit toxic fumes, gases or other
emissions that can be hazardous to the operator’s health. Where such materials are
processed, proper ventilation of the workstation is required. Check your materials
suppliers for recommended protection when processing their materials.
1.2.3
Setting up the Workplace
Measures for setting up a workplace for safe operation of the ultrasonic welder are
outlined in
Chapter 5: Installation and Setup
1.2.4
Regulatory Compliance
This product meets electrical safety requirements and EMC (Electromagnetic Compliance)
requirements for North America and the European Union.
CAUTION
Corrosive Material Hazard
Processing of many materials, such as PVC, can be hazardous to an
operator’s health and could cause corrosion/damage to the
equipment. Use proper ventilation and take protective measures.
Summary of Contents for DCX S
