Figure 5-25: Step 9
10. Position hanger blades in hanger hub slots to protrude enough from the flat faced
end of hanger hub to allow the outside edges of hanger blades to fit inside meter
housing bore.
Figure 5-26: Step 10
a) Slide assembly, flat faced end first into downstream bore of meter housing
and on to shaft.
b) Push hanger blades so upstream edges are touching downstream cone.
c) Push hub forcing hanger blades outward contacting meter housing bore.
d) Rotate downstream hanger assembly lining up upstream and downstream
hanger blades.
e) Tap downstream edges of downstream hanger blades with a soft headed
hammer to insure the blades are against the downstream cone.
Installation and maintenance instructions
Disassembly and assembly instructions
3-9008-011
October 2019
Installation and maintenance instructions
51
Summary of Contents for Daniel PT
Page 2: ...2 ...
