User Manual
Introduction
QCL-MAN -CT2211-Aerosol-Leak-Detection-System-Rev F
October 2015
Introduction
1
1
Introduction
The aerosol leak detection system described in this document has been quality control
tested and left the manufacturer in pristine condition. To achieve the correct and safe
operation of the product, it must be transported, installed, operated, and maintained
as described by the manufacturer.
This manual contains all the information required to operate the leak detection
system, including basic maintenance and troubleshooting information. Please read the
manual carefully before you start work on the leak detection system, as it contains
important information that must be followed to guarantee the correct operation of
the system and the safety of personnel. The manual is divided into sections, which
allows you to rapidly find the information you need.
Cascade Technologies is committed to continuously improving its products and
documentation. Every effort will be made to include any sensor modifications by the
manufacturer in the documentation. However, it should be noted that this document
reflects the supplied sensor as of the revision number and date on the front cover.
Should you require further information or should particular problems arise that are not
covered within this user manual, then refer to the Leak Detection System Installation
and Service Manual. Additional help can also be requested from Cascade Technical
Support ([email protected]) or Cascade Technologies distribution partners.
1.1
Qualified personnel
These operating instructions have been prepared for technically qualified personnel
who have been specially trained or who possess appropriate knowledge in the field of
instrumentation and control.
Knowledge of the safety information within this user manual and its technically correct
implementation are prerequisites for danger-free installation, commissioning,
operation and maintenance of the system. Only qualified persons have the required
specific knowledge to correctly interpret the general safety information and warnings
given in this user manual and thus apply them to the particular application.
1.2
Safety
During the manufacturing process of the aerosol leak detection system, a rigorous set
of safety and quality checks is performed to ensure that the equipment meets and
exceeds the safety requirements for the system. In order to maintain the operational
performance and safety of the control system, the correct installation, use, and
maintenance procedures detailed by the manufacturer must be adhered to.
The aerosol leak detection system uses no ionizing radiation.
Certain parts of the Leak Detection system carry dangerous voltages. All housings
must be closed with covers in place and the sensor head mounted and connected to
the air arch before switching on. Death, personal injury, and/or damage to persons
and/or property may result if this is not observed.
