ControlWave Instruction Manual (CI-ControlWave)
2-20 Installation
Revised
Nov-2010
SW1 Setting
Function
Mode
3
Use/Ignore
Soft Switches
Controls the use of soft switches. Values are:
ON
(Enable user-defined soft switches configured in flash
memory;
factory default
)
OFF
(Disable soft switch configuration and use factory
defaults)
Note
: Setting both switch 3 and switch 8 to
OFF
(closed)
sets all serial communication ports to 9600 bps
operation. All serial communication ports must be
set at 9600 bps before WINDIAG can perform
communication tests.
4
Core Updump
(see
Section
3.6
)
Causes the ControlWave to perform a core updump,
provided you have set the mode switch (SW3-3) to
Recovery mode or properly sequenced the Run / Remote /
Local switch on the PSSM. Values are:
ON
(Disables core updump;
factory default
)
OFF
(Core updump via PSSM Run/Remote/Local switch
or mode switch SW3-3)
5
SRAM Control Manages SRAM contents following a low power situation
or a power outage. Values are:
ON
(Retain values in SRAM during restarts;
factory
default
)
OFF
(Reinitialize SRAM) – Data in SRAM lost during
power outage or re-start.
6
Redundancy
Enable /
Disable
Specifies whether this ControlWave is part of a redundant
pair. Values are:
ON
(Redundancy Disabled. Not part of redundant pair;
factory default
)
OFF
(Redundancy Enabled. This ControlWave is one of
two in a redundant pair)
7
Unit A / Unit B Specifies whether this ControlWave is the “A” or “B” unit in
a redundant pair. Values are:
ON
(“A” unit in the redundant pair;
factory default
)
OFF
(“B” unit in the redundant pair)
Note:
If SW1-6 is
ON
, the system ignores SW1-7.
8
Enable
WINDIAG
Suspends normal operation and allows diagnostic
routines. Values are:
ON
(Permits normal system operation, including the boot
project, and disables the WINDIAG diagnostics from
running;
factory default
)
OFF
(Allow WINDIAG to run test; disable boot project.)
Note
: Setting both switch 8
and
switch 3 to
OFF
(closed)
sets all serial communication ports to 9600 bps
operation. All serial communication ports must be
set at 9600 bps before WINDIAG can perform
communication tests.
