ControlWave Instruction Manual (CI-ControlWave)
3-34
I/O Modules
Revised Nov-2010
Software Configuration
To use data from a UDI module you must add a
CW_HSC12
board in
ControlWave Designer’s I/O Configurator, and then configure it.
The I/O Configurator is where you specify the usage for each input
using the
Select Filter
list box.
Figure 3-29. Selecting Input Type in ControlWave Designer I/O
Configurator
Choose one of the following:
“HSC Channel”
to select a 20 microsecond delay for 10 kHz high
speed counter applications.
“1 MS”
to select a 1 millisecond delay for a low speed
counter application.
“30 MS”
to select a 30 millisecond delay for a polled
input. This is for general purpose inputs or
contacts where contact bounce may apply.
See the
ControlWave Designer Programmer's Handbook
(D5125) for
more information. That same manual includes an
I/O Mapping
section
that describes, for advanced users, the I/O map for this module.
