Chapter 5 Software Operation 37
RDU-S Rack Data Unit User Manual
Figure 5-46 SN DI sensor configure window
Note
1. At most three SN-3C dry contact sensors, three SN-2D door dry contact sensors and one SN-L leak detection sensor can be
configured.
2. The serial numbers of the sensors will be displayed in the
Address
column automatically.
4. Select the
TH Sensor Configure
tab, and the window shown in Figure 5-47 will appear.
You can set the positions of the temperature and humidity sensors. Click
Apply
to complete the configuration.
Figure 5-47 TH sensor configure window
Note
1. At most ten SN-TH temperature & humidity sensors can be configured.
2. The serial numbers of the sensors will be displayed in the
Address
column automatically.
3. At most eight IRM series temperature sensors and eight IRM series temperature & humidity sensors can be connected with the
system. After NForm is connected, when IRM series sensors are used, the system supports at most ten temperature monitoring
points and eight humidity monitoring points. The address range of the ten temperature monitoring points is 10, 11, 12, 13, 20, 21,
22, 23, 30 and 31. The temperature monitoring points beyond this address range will not be displayed in the NForm.
PDU
Click the
PDU
node, and the window shown in Figure 5-48 will appear.
Summary of Contents for RDU-S
Page 2: ......
