RELEASED: 10/2/2006
Page 18
COMMUNICATI0NS
HSD SERIES OPERATION AND MAINTENANCE
This is an unpublished work protected by the United States copyright laws and is proprietary to EMCEE Communications.
Disclosure, copying, reproduction, merger, translation, modification, enhancement or use by anyone other than authorized
employees or licensees of EMCEE Communications without the prior written consent of EMCEE Communications is strictly
prohibited.
Copyright © 2006 EMCEE Communications. All rights reserved.
This copyright notice should not be construed as evidence of publication.
To remove the Power Amplifier module, remove the amplifier status/power
connector. Remove the RF input and output connectors. There are four retaining
screws that install upward though the bottom of the main chassis into the Power
Amplifier module. Remove the four screws and using the handle slide the Power
Amplifier module forward out of the main chassis.
When tightening the RF connectors during re-assembly, do not over-tighten the
connectors.
HSD Transmitter Front Panel View
(Fully Loaded Chassis)
Important Note: Do not use the cabinet rack ears or module handles to
support the weight of the equipment. The handles are only to be used to
slide the cabinet or modules in and out of their mounting locations. The
rack mount rails must be used to support the weight of the transmitter
chassis!
