EMBRON HATTELAND HT B30G STC M Series, User Manual

Page: 97 / 114

97
WakeOnLan (WOL) function
Appendix
IND100077-225
DOC207811-1 - Revision 01
Hatteland Technology AS | www.hattelandtechnology.com | Enterprise no: NO974533146 Page 8 of 9
3.3 Running the tests
Open Network settings and locate the network adapter you will be using for WoL. Right click at select
“Status”.
Within status, select “Details”. And you will get the window below. In this window, “Physical Address”
is your Mac address.
DOC207811-1 - Revision 01
Hatteland Technology AS | www.hattelandtechnology.com | Enterprise no: NO974533146 Page 9 of 9
Open your WoL Magic package sender of your choice on a different computer on the same network or
a direct LAN connection between the two units and enter the IP address, Mac address and set the
subnet to 0.0.0.0(Local Network) of the unit you wish to power on. The most important value here is
the Mac Address and Subnet Mask.
After you have shut down the target computer, click “Wake Up” and the target computer will power
on.
If you have multiple ports for the same network card (e.g Intel Port 1 and Port 2) both of these ports
needs to be individually activated in order to receive WoL package and power on.
For Realtek, if you have activated one of the ports for WoL, then all of the ports are able to receive
the WoL signal.
4 Conclusion
You have now completed and verified the functionality of WoL on your HTB30 Computer.
If above test was unsuccessful, please look over your settings again according to chapter 3 and try
again.