13
10.1 – MEASUREMENT TYPE SELECTION
Once entered SETUP menu it’s possible to select the required type of
measurement parameter. Default is to pH
Pressing – and + buttons a loop menu is entered , user can select
among 2 measurements parameters: pH or RX (mV).
To confirm selection
press OK
The program will enter Password menu.
pH
flashing, display visualises pH value not to be
considered since calibration is yet to be completed
To select
OK
Moving to SETPOINT menu
mV RX
flashing, display visualises a RX value not
to be considered since calibration is yet to be completed
To select
OK
Moving to SETPOINT menu
10.2 – TEMPERATURE: SELECTION CELSIUS OR FAHRENHEIT
Press OK, select temperature reading either in Celsius degrees or Fahrenheit degrees (°C or °F).
To shift use
– or + Press OK to confirm selection
OR
10.3 – TEMPERATURE COMPENSATION
The pump allows to select manual temperature compensation, that is setting the temperature at the same
value of the system to be treated and such value wi ll remain constant.
Also it’s possible to switch from C° (celsius defau lt) to F° Fahrenheit.
To select manual temperature compensation display will flash OFF
pressing OK display will flash default temperature 25.0 °C.
Using + or – buttons it is possible to change this value. When the
desired value is reached press OK to memorize and move on.
10.4 – DELAY OF DOSING OPERATION AFTER SWITCHING “ON” THE UNIT
Due to electrodes time polarization inertia or plant installation characteristics or previous programming data, the
pump has the possibility to set a delay from the ti me the pump is switched ON to the concrete measuring, control
and dosing operations. It will start measuring operation after 3 seconds (default) from switch ON.
It’s a safety measure to ensure a correct electrode reading before activating the dosing pump.
Using – or + it's possible to set delay time, from 0 to 99 min.59 sec.
To shift from minutes to second
press Right arrow
Press OK to confirm
