EP-360 Micro panel printer
35/68
GS x n
[Name]
Set barcode printing left space
[Format] ASCII GS x n
Hex 1D 78 n
Decimal 29 120 n
[Description]
The print bar code staring positions is: 0
à
255
GS r n
[Name] Transmit status
[Format] ASCII GS r n
Hex 1D 72 n
Decimal 29 114 n
[Range] n = 1, 49
[Description] Transmits the status specified by n as follows:
n
Function
1, 49
Transmits paper sensor status
[Notes]
·
When using a serial interface
When DTR/DSR control is selected, the printer transmits only 1 byte
after confirming the host is ready to receive data (DSR signal is
SPACE). If the host computer is not ready to receive data (DSR
signal is MARK), the printer waits until the host is ready.
When XON/XOFF control is selected, the printer transmits only 1 byte
without confirming the condition of the DSR signal.
·
This command is executed when the data in the receive buffer is
developed. Therefore, there may be a time lag between receiving this
command and transmitting the status, depending on the receive
buffer status.
·
When Auto Status Back (ASB) is enabled using
GS a
, the status
transmitted by
GS r
and the ASB status must be differentiated using.
·
The status types to be transmitted are shown below:
Paper sensor status (n = 1, 49):
Bit
Off/On
Hex
Decimal
Status for ASB
0,1
-
-
-
Undefined.
2,3
Off
00
0
Paper roll end sensor: paper adequate.
On
(0C)
(12)
Paper roll end sensor: paper near end.
4
Off
00
0
Not used. Fixed to Off.
5,6
-
-
-
Undefined.
7
Off
00
0
Not used. Fixed to Off.
Bits 2 and 3: When the paper end sensor detects a paper end, the printer goes
offline and does not execute this command. Therefore, bits 2 and 3 do
UnRegister
ed
