EN
5
Installation of the BioProTT™ FlowMeasurement System
The BioProTT
TM
FlowMeasurement System consists of the BioProTT
TM
FlowMCP (1-4 channels)/
BioProTT
TM
FlowMCP-a (1 or 2 channels), a BioProTT
TM
Clamp-On, and the corresponding cables.
•
Compliance with the prescribed operating parameters and safety information must be
ensured prior to the use of the device. The user is responsible for the integration of the
device into their system, including the observation of safety aspects and electromagnetic
compatibility.
•
The following instructions must be strictly observed.
5.1
Device Description: BioProTT™ FlowMCP (1-4 channels)
The image below shows the interfaces available for the BioProTT™ FlowMCP (1-4 channels):
Figure 2: Device Description BioProTT
TM
FlowMCP (1-4 channels)
No Components
Description
1
power supply
4-pin connecting socket for terminal block with PIN assignment as shown below
2
Sensor Connector
#1-#4
D-Sub connection socket to connect the sensor to the extension cable
3
Ethernet connection connector for Ethernet / LAN cable (Modbus TCP)
4
USB connection
USB for em-tec service purposes only
BioProTT™ FlowMCP
Page 14
Copyright em-tec GmbH
D214-703 BioProTT™FlowMCP – User Manual – V4.0
