ELZAB Prima 2, User Manual

Page: 22 / 32

20
User Manual PRIMA 2 scale ELZAB S.A.
– READING OF SETTINGS
Meaning
This function shows all currently chosen settings in the User Menu
.
For example for the factory settings there
will be chosen the following data:
1. 1 3 5 0 1
‘ ‘ ‘ ‘ ‘
Protocol Type:
ELZAB EXTENDED
Transmission Speed:
9600 BITS/SEC.
Transmission
Parameters:
8-EVEN-1
Parity Checking:
NO CHECKING
Stability Condition:
HIGH STABILITY
2. 1 0 0 0 3
‘ ‘ ‘ ‘ ‘
Minimum Result:
01xe
Transmission Mode:
AFTER PRESSING
THE KEY
Transmitting the
minus:
ONLY POSITIVE
Transmitting the result
frame:
TRANSMITTING THE
RESULT FRAME
Stability waiting time:
4 SECONDS
3. 0 0 0 1 0
‘ ‘ ‘ ‘ ‘
Data receiving lock:
LOCK OFF
Transmission key lock:
LOCK OFF
Configuration
receiving lock:
LOCK OFF
Beep:
WITH BEEP
Fixed tare:
AUTOMATIC SWIT-
CHING OFF THE
TARE
4. 1 2 0 - -
‘ ‘ ‘ ‘ ‘
Turning off the display
backlight: SWITCH
OFF AFTER 15 SEC.
Power saving mode:
TURN ON AFTER 30
MIN.
Scales system:
SCALE NO. 0
Active communication
port
AUTOMATIC DETECTION
USB power source:
AUTOMATIC DETECTION
– EXIT FROM MENU
Meaning
Exit from the User Menu to the weighing mode.
6. Communication with the scale
The communication of the scale with external devices (e.g. cash register, computer) is effected via
the
CASH REGISTER/PC
connector (RS-232 interface). To communicate via the USB connector the
virtual serial port driver should be installed on the device cooperating with the scale. The driver
can be downloaded from www.elzab.pl.
The communication with external devices can be affected by functioning of the scale in the
situations like: unstable result, overloading and under loading of the scale, transmission mode
settings or the minimum result settings. The scale can react for those states in different ways
depending on its settings.
All the communication parameters can be changed in the “User Menu” . They are
permanently stored in the non volatile scale memory. The factory settings can be reset by using the
“Restore to factory settings” function. The factory settings allow the scale to cooperate
with every cash register produced by ELZAB SA factory which was approved by the Ministry of
Finance since 2001.