ELZAB Prima 2, User Manual

Page: 18 / 32

16
User Manual PRIMA 2 scale ELZAB S.A.
– PARITY CHECKING
Setting value Meaning
^
NO CHECKING
CHECKING ENABLED
The parity checking means that bytes with the wrong parity bit
are discarded, and the scale signalizes it by a beep.
– STABILITY CONDITION
Setting value Meaning
THE HIGHEST STABILITY
^
HIGH STABILITY
LOW STABILITY
THE LOWEST STABILITY
This parameter determines the criterion of the result stability.
If the criterion is not met, the result of weighing is considered
as unstable. The smaller the number of this setting the
stringent the stability criterion. A stable result is an obligatory
condition for activation of main scale functions: zeroing,
tarring, weighing and sending the measurement result. If after
loading the scale doesn’t send the result or send it with a few
seconds delay, the stability criterion should be broadened,
that is the number of setting should be increased.
– MINIMUM RESULT
Setting value Meaning
00 x e
^
01 x e
02 x e
04 x e
05 x e
10 x e
20 x e
50 x e
Specifies the minimum result sent by the scale
and the minimum automatically disabled tare value.
– TRANSMISSION MODE
Setting value Meaning
^ AFTER PRESSING THE KEY
The result is sent by scale only at the request of the operator e.g.
after pressing the key or by the request through the interface.
AUTOMATIC. STABLE
The result is automatically sent by scale, just once, after loading
and stabilizing the indication. Before putting the commodity on the
platter the display should show and . The result
is sent only when the
MINIMUM RESULT
setting is deferent from
.
Example: the
“ MINIMUM RESULT
” value was set at
that is 20 x e = 040 g the load put on scale was 036 g -> the scale
doesn’t send the result, the load was increased to 042 g -> the
scale sends the result
.
AUTOMATIC.CONTINUOUS
The scale sends the results continuously at 0,12 sec. time intervals.
The unstable results are not sent but the result frame (containing
the signs 0x20 in place of the digits) can be sent if the “
SENDING
FRAME
” was set at that is for “
STABLE AND
UNSTABLE”
value
.