Elvox 46540.F04, Installation And Operation Manual, Page: 66 / 96

64 EN
2 - Input relay name and select hold time.
3 - Go to Schedule tab. The setting steps for schedule for alarm out are similar to normal schedule setup (see Chapter 6.3 Schedule Recording for details).
To set up buzzer:
4 - Go to Main Menu Setup Alarm Alarm Out Buzzer.
5 - Checkmark Buzzer and set buzzer alarm hold time. This would trigger the buzzer when the system is on an alarm.
Note: The alarm out and buzzer must be enabled in prior and their schedules must cover the schedule of other alarm types.
5.6 Manual Alarm
Some models may support this function.
Go to Main Menu Manual Alarm interface as shown below.
6 Network Configuration
Network configuration includes six submenus: network, sub stream, Email, server, NAT and other settings. Network settings must be configured if DVR is
used for monitoring over network.
6.1 Network
To set up network:
1. Go to Menu Setup Network Network tab. Refer to Fig 6-1:
Fig 6-1 Network Configuration-Network
2. Set HTTP port. The default HTTP port is 80. If the value is changed, you shall add the port number when typing IP address in IE address blank. E.g., if
HTTP port is set to 82 and IP address is http://192.168.0.25, you should input the following IP address: http://192.168.0.25:
82 into IE browser.
3. Set server port. The default server port is 6036.
4. Connect internet. There are three ways to connect internet.
If you have a DHCP server running and would like your DVR to automatically obtain an IP address and other network settings, check the checkbox beside
“Obtain an IP address automatically”. Then the device will distribute IP address, subnet mask, and gateway IP and DNS server.
If you want to configure your own settings, disable “Obtain an IP address automatically” item and input the IP address, subnet mask, gateway IP and DNS
server.
If you connect internet through PPPoE, disable “Obtain an IP address automatically” item and check PPPoE checkbox and then enter username and
password. Once the setup is completed, your DVR will automatically dial up into your network.
5. Test the effectiveness of the network by clicking “Test” button after you set up the network.
6. If the network is well connected, please click “Apply” button to save the setting.
Choose alarm out and click Alarm button to trigger alarm manually. Click Clear button to clear the alarm.