
61
EN
6 -Click “Setting” button to pop up a dialog box as shown below.
Buzzer:
If selected, the local buzzer would be activated on an alarm.
Show Full Screen:
If selected, there will pop up the chosen channel on the monitor on an alarm trigger.
To Alarm Out:
If selected, this would trigger external relay output on an alarm.
Email:
If selected, the AHD Hybrid DVR will send an email alert to the preconfigured email address in case of a sensor based alarm from the particular input.
Snap:
If selected, the system will snap images of the checked channels on an alarm and save them in the HDD automatically.
- Go to “To Record” tab. Select recording channels. It would be recorded in case of an alarm. Click OK button to save the setting.
- Go to “To PTZ” tab. Set preset, cruise and track options for a PTZ in case of a sensor based alarm. Single or multiple PTZ units could be programmed to
perform this function on the same alarm.
- Go to “Schedule” tab. The setting steps for schedule for sensor based alarm are similar to normal schedule setup. You can refer to Schedule Recording
for details. This step is very important for sensor alarm. Even if you have enabled the sensor alarm for all channels and set up the trigger, you will not see
the result of sensor alarm if no schedule is added.
If you have set schedule for sensor based recording in the same timeline, recordings can also be triggered.
5.2 Motion Alarm
Operate the following steps to configure motion based alarm:
Motion alarm includes two sub menus: motion and schedule. The steps to set motion alarm are as follows:
1 - Go to Main Menu
Setup
Alarm
Motion.
2 - Enable motion alarm, set alarm hold time which refers to the time till which the system will wait for further detection of motion. e.g. If the holding time is
set to 10 seconds, once the system detects a motion, it will go to alarm but would not detect any other motion alarm (specific to channel) until 10 seconds.
If there is other motion detected during this period it is considered it as continuous movement, otherwise it will be considered as a single motion.
Summary of Contents for 46540.F04
Page 95: ...93 ...