www.prolight.co.uk
9RE Beam
User Manual
10
Discharge Lamp Warnings/Replacement
Discharge Lamp Warning:
This fixture is fitted with a YODN MSD 260R9 Discharge Lamp, which is highly prone to damage if
improperly handled.
NEVER
touch the lamp with your bare hands, as the oil from your hands will shorten
the life of the lamp.
NEVER
move the lamp until the unit has had the appropriate time to cool. Discharge
lamps are
NOT
covered under the warranty that comes with this fixture. Avoid switching the fixture
ON
and
OFF
repeatedly in short durations as this will reduce the lamps life and intensity. To achieve the
intensity discharge lamps are renowned for, the lamp uses gas sealed in a high pressure environment.
Due to this high pressure involved with the manufacture of the lamp, it
MAY EXPLODE DURING
PROLONGED EXTENSIVE USE
. This risk is increased with age and we recommend extra care is taken
when dealing with older lamps. The lamp must be replaced at the end of its recommended duty cycle.
Extreme caution should be taken when operating this or any fixture fitted with a discharge lamp.
Lamp replacement:
To ensure a safe lamp change please read the following instructions carefully.
The YODN MSD 260R9 Lamp
MUST
be replaced every 2000 hours or when damaged and/or deformed.
When the lamp needs replacing the display will show
“Warning!!! Change Lamp”
. This will then be
shown on each startup until the lamp is replaced. Press any button to continue operation.
See page 11 for instructions on changing the lamp.
Only use GENUINE YODN Lamps. Other branded lamps will cause damage and will void the
fixtures warranty.
Disconnect the fixtures power supply before replacing the lamp. Let the fixture cool for a minimum
of 60 minutes before replacing the lamp.
Never touch the lamp with bare hands, always wear gloves as oil from hands will shorten the lamps life.
Make sure all covers/casings are replaced/secured before operating the fixture to prevent risk and/or
damage to the eyes retina.
Discharge Lamp Installation:
2.
4.
1.
3.
