WEP-2L. User manual
40
•
•
•
•
•
•
•
•
•
•
•
•
•
•
To apply a new configuration and save setting to non-volatile memory, press «Apply». Press «Cancel» to discard
the changes.
5.7 The «Network Settings» menu
5.7.1 The «System Configuration» submenu
Hostname
– nertwork name of the device, specified by string from 1 to 63 characters; latin uppercase and
lowercase letters, numbers, hyphen «-» (hyphen can not be the last character in the name);
AP Location
– domain of the EMS management system tree host where the access point is located;
Management VLAN
:
Disabled
– Management VLAN is not used;
Terminating
– the mode in which the management VLAN is terminated at the access point; in this
case, clients connected via the radio interface do not have access to this VLAN;
Forwarding
– the mode in which the management VLAN is also transmitted to the radio interface
(with the appropriate VAP configuration).
VLAN ID
– the VLAN ID used to access the device, takes values 1-4094;
Protocol
– select protocol for connection of the device via Ethernet interface to service provider network:
DHCP
– operation mode, when IP address, subnet mask, DNS server address, defualt gateway and
other parameters required for operation are obtained from DHCP server automatically;
Static
– operation mode where IP address and all the necessary parameters for WAN interface are
assigned statically. If «Static» is selected, the following parameters will be available to set:
Static IP
– device WAN interface IP address in the provider network;
Netmask
– external subnet mask;
Gateway
– address, to which the packet is sent, if the route in routing table is not found for it.
Primary DNS server, Secondary DNS server
–
IP address of DNS servers. If DNS servers' addresses are
not allocated automatically via DHCP, set them manually.
To apply a new configuration and save setting to non-volatile memory, press «Apply». Press «Cancel» to discard
the changes.
