WEP-2L. User manual
38
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
General VLAN ID
– a tag will be removed from the specified VLAN ID and the traffic of this VLAN will pass to
the client without a tag. When traffic passes in the opposite direction, untagged traffic will be tagged with
General VLAN ID;
Station Isolation
– when checked, traffic isolation between clients in the same VAP is enabled;
Priority
– select prioritization means. Defines the field on the basis of which the traffic transmitted to the
radio interface will be distributed in WMM queues:
DSCP –
will analyze the priority from the DSCP field of the IP packet header;
802.1p –
will analyze the priority from the CoS (Class of Service) field of the tagged packets.
Maximum Stations
– the maximum number of clients connected to the virtual network;
Minimal Signal
– signal level in dBm below which the client equipment is disconnected from the virtual
network;
Security Mode
– wireless access security mode:
Off
– do not use encryption for data transfer. The access point is available for any subscriber to
connect;
WPA, WPA2, WPA/WPA2 –
encryption methods, if you select one of the methods, the following setting
will be available:
WPA Key –
key/password required to connect to the virtual access point. The length of the key
makes from 8 to 63 characters;
WPA-Enterprise, WPA2-Enterprise, WPA/WPA2-Enterprise –
wireless channel encryption mode, in
which the client is authorized on the centralized RADIUS server. To configure this security mode, you
must specify the parameters of the RADIUS server. You also need to specify a key for the RADIUS
server. If you select one of the methods, the following setting will be available:
Domain
– user domain;
IP Address of RADIUS Server –
RADIUS server address;
Port of RADIUS Server
– port of the RADIUS server that used for aithentication and authorization;
Password of RADIUS Server
– password for the RADIUS server used for authentication and
authorization;
Use Accounting through RADIUS –
when checked, «Accounting» messages will be sent to the
RADIUS server;
Use Other Settings For Accounting:
IP Address of RADIUS Server for Accounting
–
address of the RADIUS server, used for
accounting;
Password of RADIUS Server for Accounting–
password for the RADIUS server used for
accounting.
Port of RADIUS Server for Accounting
– port that will be used to collect accounts on the RADIUS
server:
Use Periodic Accounting –
enable periodic sending of «Accounting» messages to the
RADIUS server. You can set the interval for sending messages in the «Accounting
Interval» field.
