WEP-2L. User manual
30
•
•
•
•
•
•
•
•
•
•
•
•
STBC
– Soace-Time Block Coding method dedicated to improve data transmission reliability. The field is
available only if the selected mode of operation of the radio interface includes 802.11n. When checked, the
device transmits one data flow through several antennas. When unchecked, the device does not transmit
one data flow through several antennas;
Beacon Interval, ms
– beacon frames transmission period. The frames are sent to detect access points. The
parameter takes values from 20 to 2000 ms, by default – 100 ms;
Fragmentation Threshold
– frame fragmentation threshold, bytes. The parameter takes values 256-2346, by
default – 2346;
RTS Threshold
– after what quantity of bytes the Request to Send will be sent. Decreasing of the
parameter's value might improve access point operation when there are a lot of clients connected. However,
decreasing of the parameter's value will reduce general bandwidth of wireless network. The parameter
takes values from 0 to 2347, by default – 2347;
Aggregation
– enable support for AMPDU/AMSDU;
Short Preamble
– use of the packet short preamble;
Broadcast/Multicast Rate Limiting, p/s
– when the flag is set, transmission of broadcast / multicast traffic
over the wireless network is restricted. Specify the limit for broadcast traffic in the popup window (p/s);
Wi-Fi Multimedia (WMM)
– WMM support activation (Wi-Fi Multimedia);
Enable QoS
– when the flag is set, the setting of Quality of Service functions is available.
The following functions are available for quality assurance configuration:
AP EDCA parameters
– access point settings table (traffic is transmitted from the access point to the
client):
Queue
– predefined queues for various kinds of traffic:
Data 3 (Background)
– low priority queue, high bandwidth (802.1p: cs1, cs2 priorities);
