RR-10 wireless signal repeater. User manual
10
•
•
•
1.5 Resetting to factory settings
To reset the device to factory settings, press and hold the «F» button for more than 3 seconds until the
indicator on the front panel flashes red. The device will automatically restart within 5 seconds, and the
indicator will light up red. When the device is ready, the indicator flashes red slowly.
1.6 WPS button management
The device supports connection to the router Wi-Fi networks via WPS. To configure the connection, activate
the WPS function on the router and press and hold the WPS button on the back of the device for 3 seconds.
After that the device will connect to the router automatically. Connection to the router takes no more than two
minutes. In case the connection is not successful, try again and make sure that the WPS function on the
repeater was activated no later than 2 minutes after the WPS function was activated on the router.
1.7 Delivery package
RR-10 standard delivery package includes:
RR-10 wireless signal repeater;
230/5.3V 2.0A power adapter;
Device quick configuration guide.
By default, the DHCP server is running on all interfaces;
LAN interface address is 192.168.0.1; the subnet mask is 255.255.255.0;
the username/password for access via the web interface: admin/password.
Configuring with WPS technology as a client is only available for non-configured devices. Before
using the WPS button, you must reset the device to the factory settings.
After configuring the device, a DHCP client is launched on all interfaces.
