Assembly Instructions
7
3.
Attach the coulter assembly to the frame
For this step you will need the coulter shank, the coulter blade, the coulter arm, the coulter assembly
parts bag, and all the remaining parts in the parts bag.
a)
Install the roll pin in the coulter assembly parts bag into the hole on one end of the coulter
shank.
b)
Mount the parts that clamp the coulter shank to the frame. You will need the 2 coulter shank
clamps, the 2 square head bolts, and the 4 bolts, washers, lock washers, and nuts. These parts
should be assembled as shown in Figure 7.
c)
Slide the coulter shank into position as shown in Figure 8. Clamp the coulter shank in place
by tightening each bolts a little at a time until the coulter shank is secured in place.
Figure 6: Finished Seeder Assembly
Figure 7: Assembled Coulter Shank
